Setting up Digital Performer 9 to record and host MIDI notes from Maschine You can of course use a similar method for instruments you want sending Sounds to MIDI Channel. Learning the hard way, it's best to do all of your MIDI recording on the main track with Maschine loaded on to it!! Otherwise it's a total PITA to stop feedback loops and other ridiculous things from happening, at one point I had Maschine firing all 16 pads! Set up a MIDI host track with a simple send, (with MIDI channels selected for more complex set ups of course), and drag MIDI there. that do not loan themselves well to to Maschine's sequencer onto a separate track. In my case, and probably a lot of our cases, my point here is to export MIDI to Reaper, then record the single hits etc. The input is obvious, the Hardware MIDI input, with the channel you have the Group on. The key is to set the track with the VSTi on it to record the output of the track as shown below. With Reaper unlike Live everything is easier if you use the actual track the VSTi is on. I did not test Reaper with the Audio Unit version, It might actually work though since Reaper uses a unique way to address recording the output of a VSTi. REAPER MIDI MONITOR INPUT HOW TOThis is using the instructions D-One provides above on how to get Maschine to send Groups to a single track. OK Setting up Reaper to record and host MIDI notes from Maschine. All the others receive spotty attention from other developers of soft and hardware. Logic and DP are very unique, and only Logic gets a good amount of developer attention that way since it's in the top four DAWs, Logic, PT, Cubase, and Live. REAPER MIDI MONITOR INPUT PLUSI started messing around with MPE instruments and a Roli Seaboard, got the latest version of Logic, but ended up demoing Reaper and liking it's ridiculous amounts of flexibility, plus best rendering options of any DAW IMO.ĪFA issues, of all the DAWs Cubase's strongest asset is how good they are at keeping up with standards. I've used DP and Live for years, before that it was Logic and Live. REAPER MIDI MONITOR INPUT SOFTWAREGot it working with Reaper! Reaper has an option to record the MIDI coming 'out' of a track as you're recording MIDI, and this works, with one track even! You can also set up a separate track to record things like cymbal splashes and other one off which was my whole point with this!ĭP still eludes me, it's probably a no go because of the way DP treats MIDI as separate from software instruments, but IMO it still might be possible. I'll attach an Ableton 10 project with 2 Groups setup and ready to go for you to have a look. Because the Group is set to send MIDI to Host and we used batch setup to ensure each Pad sends a different note starting from C3 in MIDI Channel 1 it will work fine. Now in Live you just need to set MaschineVST as the MIDI input/output and select the same MIDI Channel, in this case, it's Channel 1.Īnd there you go. (This will make sure all the sounds inside the group are triggered by MIDI notes starting on C3 and up) Group MIDI Batch Setup > Sounds to MIDI notes. Make sure all Pads are selected when changing SOUND level MIDI settings. Maschine's Pads can indeed send MIDI to DAW (without using MIDI Mode) if you configure them to do so, I guess the DAW has to support receiving MIDI from a VSTi, most do, I have personally tested Ableton Live, Cubase & Bitwig.įor Reaper, I can't help much as I don't use it and find it's MIDI track settings a bit confusing but I can help you in Live and maybe you can recreate the settings in Reaper.Īssuming you want to use Sample Groups only: I asked because depending on what you want to do settings might change.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |